IBM Books

Addendum to Nways Manager for Windows NT Installation Guide

Installing the Configuration Tools

Reference to Checklist:This section corresponds to step 15.
Note

This section applies to those who either need help with the installation of the Configuration Tools following the Nways Manager installation sequence, or did not install the Configuration Tools when Nways Manager was installed, but want to install them now. If neither of these conditions apply, then continue with "Installing Nways Remote Monitor for Windows NT".

If you selected the Configuration Tools to be installed with the Nways Manager, then the process begins at step 5. If this is an installment of only the Configuration Tools, follow all of the steps to install the Configuration Tools provided with Nways Manager-Suite:

  1. Insert the Nways Manager Version 2.0 CD into the drive. If autorun is enabled, it will automatically begin the process. If autorun is disabled, click Start -> Run.... Enter e:\setup.exe, where e is the CD drive.

  2. Click Next in the Welcome dialog box.

  3. Select the components to be installed.

  4. Click Next.

  5. Select the configuration tools to install.

  6. Click Next.

  7. Click Next.

  8. Click Next in the Configuration Program Installation dialog box.

  9. Click OK. (Steps 7, 8, and 9 will repeat until all selected tools have been installed.

  10. When all tools have installed, you will see steps 26 and 27 of the Nways Manager sequence of installation.

[ Top of Page | Previous Page | Next Page | Table of Contents ]